Platinum Installs provides garage floor coating across DFW — including Plano and the surrounding area. Here is what to know before you start your project.
Plano homeowners tend to take their property seriously, and a garage floor coating is one of the more practical upgrades you can make. It cleans up instantly, handles vehicle traffic without showing wear, and holds up in a climate that is genuinely hard on concrete. This post covers what you need to know before making a decision: what systems exist, what they cost, and what the installation day actually looks like.
Most professional garage floor installers in DFW work with one of two systems or a combination of both.
This is the most common residential system in the area. A base layer of 100% solids epoxy goes down first, then decorative vinyl flakes are broadcast across the wet surface, and a clear polyaspartic or polyurethane topcoat seals everything in. The result looks like terrazzo — it hides imperfections in the slab, resists hot-tire pickup, and is easy to sweep and mop. Colors range from subtle neutrals to bold blends. This is the system we install most often in Plano.
Polyaspartic is a newer chemistry that cures faster, handles UV exposure better, and is more resistant to yellowing over time. It is a good choice if the garage gets direct sun through the door, or if you want to minimize curing time. Some contractors install a 100% polyaspartic system without epoxy underneath — that can work, but a system with a proper epoxy base layer will typically bond more reliably to older or textured slabs.
For a standard two-car garage in Plano (roughly 400–480 square feet), a professionally installed decorative flake system typically runs between $2,000 and $3,200. That range covers diamond grinding, a base coat, full flake broadcast, and a polyaspartic topcoat with a written warranty.
Factors that move the price up:
Factors that move it down:
A standard two-car garage in Plano runs roughly $2,000–$3,500 for a full decorative flake system — epoxy base coat, full flake broadcast, and polyaspartic topcoat. That includes diamond grinding. We offer free on-site estimates with no obligation.
A professionally installed epoxy and polyaspartic system typically lasts 15 to 20 years in Plano and the greater DFW area. The key factors are proper diamond grinding and using 100% solids epoxy products rated for Texas heat.
Call us at (214) 813-7474 or visit platinuminstallstx.com to request a free on-site estimate. We will come to your Plano home, assess the slab, walk you through system options, and give you a written quote.
We give free on-site estimates in Plano — no pressure, no obligation. Usually takes about 30 minutes and you will leave with a written quote.
Schedule a Free EstimateThis is the part most people do not think about until they are scheduling it. For a two-car garage, installation takes one full day — typically 7–9 hours. Here is the rough sequence:
You can typically walk on the floor the next morning and drive on it within 24–48 hours depending on conditions.
A professionally installed system in Plano, maintained normally, should look good for 15 years or more. The topcoat will show light wear in high-traffic areas first. If that happens, a topcoat recoat is much less expensive than a full reinstall and can refresh the floor significantly.